Professional diamond cutter 2.3 mm

Professional cutter with diamond surface and truncated cone-shaped tip
Suitable for treating the surface of smaller nails and for lifting and removing cuticles
Ideal for fingernails
Autoclavable
Diameter 2.3 mm

Ref: CM654

_{Prices on Tecniwork.it are visible after logging into the website reserved to professionals only.}

Discover also:

# Burs

# Diamond Burs

Need any help?

Write your e-mail

Read our F.A.Q.

Purchase securely

Thousands of satified customers

Quick delivery

in 2/3 working days

Product description

Professional bi-directional stainless steel micromotor cutter with diamond surface and truncated cone-shaped tip.

Suitable for treating the surface of the smallest nails and for lifting and removing cuticles, ideal for hand nails.

The working part is covered with top quality diamond grains, aggregated with a special process that guarantees a surface with a homogeneous and long-lasting distribution, for excellent working results.

Made of hygienic stainless steel and easily disinfected and sterilised up to 180°C: in an autoclave, with dry heaters or chemical solutions.

1 pc

Details

Diameter: 2.3 mm

Recommended speed of use: 1,000 to 45,000 rpm

Hints

Correct hygiene:

Spray with Ref. CP709, ENZIMASEPT SPRAY, ready-to-use instrument pretreater and wait at least 5 minutes.

Never use abrasive metal brushes for cleaning.

Rinse and proceed with simultaneous cleaning, cleansing and disinfection with Ref. CP708 ENZIMASEPT, concentrated disinfectant detergent, which must be diluted in water and can be used in ultrasonic equipment.

Contact time with instruments is 10 minutes, maximum 15 minutes, after which rinse thoroughly with demineralised water and dry.

Proceed with the usual sterilisation techniques (autoclave etc.).

Caution: do not use temperatures higher than 180°C.

For a better abrasive performance, we recommend cleaning the diamond cutter with the specific silicon carbide stone, Ref. CM406; this is a fine-grained white stone which should be moistened with water before gently sliding the cutter over its surface.

Documents