Home | Customer Service | Our Services |
Prices on Tecniwork.it are visible after logging into the website reserved to professionals only.
Professional bi-directional micromotor cutter with spiral cut diamond surface and truncated cone-shaped tip.
Ideal for removing, reducing and finishing calluses and thickenings.
The special diamond surface guarantees effective work on large surfaces, with high abrasive power and low heat development, for fast and precise finishing.
Made of hygienic stainless steel and easily disinfected and sterilised up to 180°C: in an autoclave, with dry heaters or chemical solutions.
1 pc
Diameter: 8.0 mm
Recommended operating speed: 1,000 to 15,000 rpm
Correct hygiene:
Spray with Ref. CP709, ENZIMASEPT SPRAY, ready-to-use instrument pretreater and wait at least 5 minutes.
Never use abrasive metal brushes for cleaning.
Rinse and proceed with simultaneous cleaning, cleansing and disinfection with Ref. CP708 ENZIMASEPT, concentrated disinfectant detergent, which must be diluted in water and can be used in ultrasonic equipment.
Contact time with instruments is 10 minutes, maximum 15 minutes, after which rinse thoroughly with demineralised water and dry.
Proceed with the usual sterilisation techniques (autoclave etc.).
Caution: do not use temperatures higher than 180°C.
For a better abrasive performance, we recommend cleaning the diamond burr with the specific silicon carbide stone, Ref. CM406; this is a fine-grained white stone which should be moistened with water before gently sliding the burr over its surface.
If you leave the page all the data will be lost
You have to confirm your Privacy Policy consents and information to sign up for our Newsletter.
Thank you for signing up for our Newsletter
