Professional diamond burr 6.5 mm

  • Professional cutter with diamond surface and cylindrical tip
  • Suitable for gently lowering and abrading the nail surface and reducing the length of the nails
  • Ideal for lifting and removing excess cuticles from toe nails
  • Autoclavable
  • Diameter 6.5 mm
Ref: CM659



Log in to visualise prices and purchase

Prices on Tecniwork.it are visible after logging into the website reserved to professionals only.

Purchase securely

Thousands of satified customers

Quick delivery

in 2/3 working days
Product description

Professional bi-directional stainless steel micromotor cutter with diamond surface and cylindrical tip.

Suitable for gently lowering and abrading the nail surface and reducing nail length, also ideal for lifting and removing cuticles from toenails and preparing the lamina before nail modeling.

The working part is covered with top quality diamond grains, aggregated with a special process that guarantees a surface with a homogeneous and lasting distribution, for excellent working results.

Made of hygienic stainless steel and easily disinfected and sterilised up to 180°C: in an autoclave, with dry heaters or chemical solutions.


1 pc

Details

Diameter: 6.5 mm

Recommended speed of use: 1,000 to 30,000 rpm

Hints

Correct hygiene:


Spray with a ready-to-use instrument pretreater and wait at least 5 minutes.

Never use abrasive metal brushes for cleaning.

Rinse and proceed with simultaneous cleaning, cleansing and disinfection with a concentrated disinfectant detergent, which must be diluted in water and can be used in ultrasonic equipment.

Contact time with instruments is 10 minutes, maximum 15 minutes, after which rinse thoroughly with demineralised water and dry.

Proceed with the usual sterilisation techniques (autoclave etc.).

Caution: do not use temperatures higher than 180°C.


For a better abrasive performance, we recommend cleaning the diamond cutter with the specific silicon carbide stone Ref. CM406; this is a fine-grained white stone which should be moistened with water before gently sliding the cutter over its surface.

Back to start